NEW 
|
| The
American Budgerigar Society  ~ Official Member ~ |
DIY "Do It Yourself" Cement Perch
|
Posted
by: Raenett - - December 1, 1998 * Duct or Masking Tape (to hold pipes together in the mold) * 1 - 2" Lag Screw per Perch (I think that's what they're called; they have threads on both ends) * 2 Washers per Perch (wider than the outside diameter of the pvc pipe and the appropriate size for your cage wire) * One Wing Nut per Perch (to fit the lag screw) * 1 Bag All Purpose Sand * 1 Bag Cement * 1 Tin Can (or something to hold the pipes in as a mold) Now Comes the Fun Part: Cut the pvc pipe to whatever length perches you want. If you're making more than one, cut them all at once. We have a lot of power tools, which makes it much easier. I usually make mine 6" long. Now cut each piece of pvc pipe down the center, making a seam. This is not an easy task, but the cut doesn't need to be straight, and my seams usually end up jagged. I have used wire cutters, scissors, garden shears, and a Dermal to make these cuts. Take the duct or masking tape and tape the bottom and the seam of each piece of pvc pipe, so that when you add the cement mixture, it won't leak out. Stand all of your ready to fill pvc molds in a can, open end up (I have a piece of 2x4 with holes pre-drilled to hold the molds). Mix 3 parts sand to 1 part cement and add enough water to make it kind a smooth and pourable. MIX WELL, and add more water as needed. Pour the mixture into the pvc molds (a little overflow is better than not filling completely, because some of the water in the mixture will rise to the top). Place a washer, followed by a wing nut, onto a lag screw, and place it into the center of the cement mixture. The washer will keep the screw from falling into the cement. Don't worry about any dribbles down the side of the molds, this is mostly water. Let the cement set for several days,... the longer the better. If you become over anxious, your perches will fall apart when you take them out of the mold. I learned this the hard way. Once the cement has set, remove tape and spread the pvc pipe. Take a pair of pliers and pull the perch out of the mold by grabbing onto the screw, or in most cases you can push the perch through the mold once loosened. When out, the perch will be smooth on the surface. I roughen them up by lightly sanding. If you don't have sand paper, you can use a file, emery board, or whatever. Attach the perch to the inside of the cage, one washer up against the cement, attach the other washer on the outside, through the cage bars, and secure with the wing nut. That's it! I hope I didn't leave anything out. It sounds like a lot of work, but it really is very simple, and as I said earlier, the average cost per perch is 50 cents. The hardest part is cutting the seams and waiting for the cement to cure. Good luck! Posted
by: Raenett - - December 1, 1998 |
